نیا لو لوڈر ٹریلر Fliegl VTS 400 P

Description: Lowbed
Functionality: fully functional
Location: Oberpöllnitzer Straße 8, 07819 Triptis, Deutschland
Attention: The trailer may only be pulled by towing vehicles which guarantee the effectiveness of the ABS!
Front area: steel floor
Country of Registration: Germany
Frame: RAL 3002 Carmine Red
Tow bar: galv
axle configuration: > 3 axles
Custom-tailored transport solution
Configure your Fliegl vehicle according to your requirements. The vehicle shown is an example. Production and equipment are customized according to customer specifications
Further information
Chassis
Steel welded construction
Turntable with robust ball bearing
storage box recessed
Turntable extension
Foldable rear support
Bdebei Ri I Ejyq Smi Eeg
2 wheel chocks with holder
Aluminum side impact protection
Mud flaps at the rear across the entire width
Extendable wideners to 3,000 mm (not in rear slope)
(However
the track width of the construction machines or vehicles to be transported must not exceed the outer frame width of 2,550 mm)
Storage compartment for wooden planks in the center of the loading area
Wooden planks 70 mm for widening to 3000 mm
Tie-down eyes
low-loader type
3 pairs of tie-down points
each rated at 10 tons
integrated in the front of the floor
6 pairs of tie-down anchor plates
top and side in the outer frame
each rated at 10 tons
1 x in the neck area
the rest distributed in between with a maximum distance of 1200 mm
1 x rear slope
5 pairs of pocket slots recessed in the outer frame
inside 70 x 40 mm
(can be converted to 5-ton ring tie-down eyes
not included in the scope of supply)
turntable trailer
Tow bar with tested 40 mm towing eye
Note! With a 40 mm towing eye
the permissible total weight of the truck must not exceed 18000 kg
otherwise
a 50 mm towing eye is required
Axles + Suspension
SAF drum brake axles
Axle / chassis laser-aligned
reducing tire wear and fuel consumption
Parabolic suspension with maintenance-free steel-rubber bearing and mechanical axle load equalization in the front and rear (rocker equalization)
Wheels & Tires
235 / 75 R 17.5
according to manufacturer's choice
Steel rims in twin arrangement
factory silver
Braking System
2-line compressed air braking system
Spring-loaded parking brake
2 fail-safe coupling heads at the front
with connecting lines to the towing vehicle
ABS and ALB
with ABS plug at the front
with connecting cable
Electrical System
24 Volt
multi-chamber lights
yellow LED lighting on the sides
2 white position lights at the front
2 white/red side marker lights at the rear
2 x 7-pole fail-safe plugs at the front
with connecting cable
1 LED rotating beacon with holder
switched via parking light (beacon can be removed)
2 pairs of warning signs
double LED illuminated and extendable to 3,000 mm
Floor
followed by 70 mm softwood floor
steel / diamond plate in the wheel arch area
Rear slope with 70 mm softwood floor
Access Ramps
Steel ramps
2800 mm long
750 mm wide
laterally movable
covered with wood
with gas spring support
Operating Instructions
With an axle load of 10,000 kg
an exemption permit is required
only indivisible loads are possible!!!
The stated total weight is technically possible
depending on the cargo
the total weight may not be reached while complying with the permissible axle / support and saddle loads
Country of Registration / Signs
1 with Dekra inspection and certificate (according to §13 EG - FGV)
24/7 service hotline
prepared for license plate holder
two-line
Contour marking with reflective strips according to ECE R 048
white on the sides and red at the rear
Paint finish
10-year warranty against rust-through